HP Designjet T120 HP Designjet T120 and T520 ePrinter Series - User's Guide - Page 140
Front-panel error messages
View all HP Designjet T120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
17 Front-panel error messages Occasionally you may see one of the following messages appear on the front-panel display. If so, please follow the advice in the Recommendation column. If you see an error message that does not appear here, and you feel in doubt about the correct response, or if the recommended action does not seem to solve the problem, contact HP Support. See Contact HP Support on page 137. Table 17-1 Text messages Message Recommendation [Color] cartridge has expired Replace the cartridge. See Replace an ink cartridge on page 76. [Color] cartridge is low on ink Ensure that you have a new cartridge of the same color ready. [Color] cartridge is very low on ink Ensure that you have a new cartridge of the same color ready. Depleted cartridges must be replaced to resume printing Replace the cartridges as needed. See Replace an ink cartridge on page 76. Ink system failure Contact HP Support. See Contact HP Support on page 137. Maintenance 1 advised Contact HP Support. See Contact HP Support on page 137. Maintenance 2 advised Contact HP Support. See Contact HP Support on page 137. Maintenance 3 advised Contact HP Support. See Contact HP Support on page 137. One or more cartridges appear to be missing or damaged Insert cartridges of the correct color as needed. See Replace an ink cartridge on page 76. Paper jam See The roll has jammed on page 100 or The multi-sheet tray has jammed on page 101. Paper width is smaller than the minimum size supported by the Remove the paper and load paper of the correct size. selected paper source. Load cancelled. Loaded paper is too wide. Manual unload required. Remove the paper manually and load paper of the correct size. Paper too far from lateral load line. Please try again. Remove and reload the paper. Please manually unload roll paper and try again. Rewind the roll manually. Single sheet is loaded with too much skew. Press Eject to unload paper. Remove and reload the paper. The current job has been cancelled because the roll is out of paper. Load the roll and send the job again. Load a new roll. 132 Chapter 17 Front-panel error messages ENWW