HP Deskpro 300 Compaq Deskpro Workstation 300 Hardware Reference Guide - Page 47
Using SCSISelect with SCSI Devices, Computer Setup
View all HP Deskpro 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
The cable that shipped with your workstation may look different than the one illustrated (a five-device cable). ✎ If you are installing a narrow SCSI device, you will need to attach a 68-pin to 50-pin SCSI adapter. For additional information about installing optional SCSI devices, refer to the documentation included with the device option kit, or contact your Compaq authorized dealer, reseller, or service provider. Using SCSISelect with SCSI Devices The Wide-Ultra160 SCSI host adapter includes the SCSISelect utility to configure the host adapter and to run SCSI disk utilities. To run the SCSISelect utility: s In POST Messages Enabled mode: Press Ctrl+A when the Press for SCSISelect Utility message appears during POST. s In POST Messages Disabled mode: When the Compaq logo screen appears, press any key to exit the logo screen. Immediately after exiting the logo screen, press Ctrl+A to access the SCSISelect utility. A menu appears with the following options: s Configure/View Host Adapter Settings ❏ SCSI Bus Interface Definitions - Host Adapter SCSI ID - SCSI Parity Checking - Host Adapter SCSI Termination ❏ Additional Options - Boot Device Options - SCSI Device Configuration - Advanced Configuration Options s SCSI Disk Utilities Lists all SCSI devices and SCSI ID numbers ✎ For information about configuring POST message display status, refer to the Computer Setup guide. B-6 Hard Drive Installation