HP Dragonfly 13.5 Maintenance and Service Guide - Page 70
Fingerprint reader cable, To remove the fingerprint reader cable, use this procedure and illustration.
![]() |
View all HP Dragonfly 13.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
7. Remove the four Phillips M2.0 × 3.9 screws that secure the system board to the computer. 8. Lift the left side of the system board (1) until it rests at an angle. 9. Slide the system board (2) up and to the left at an angle to remove it. To install the system board, reverse this procedure. Fingerprint reader cable To remove the fingerprint reader cable, use this procedure and illustration. NOTE: The fingerprint reader cable is included in the Cable Kit, spare part number N09288-001. Before removing the fingerprint reader cable, follow these steps: 64 Chapter 5 Removal and replacement procedures for authorized service provider parts
![](/manual_guide/products/hewlettpackard-dragonfly-135-maintenance-service-guide-93693b1/70.png)
7.
Remove the four Phillips M2.0 × 3.9 screws that secure the system board to the computer.
8.
Lift the left side of the system board
(1)
until it rests at an angle.
9.
Slide the system board
(2)
up and to the left at an angle to remove it.
To install the system board, reverse this procedure.
Fingerprint reader cable
To remove the fingerprint reader cable, use this procedure and illustration.
NOTE:
The fingerprint reader cable is included in the Cable Kit, spare part number N09288-001.
Before removing the fingerprint reader cable, follow these steps:
64
Chapter 5
Removal and replacement procedures for authorized service provider parts