HP Dragonfly 13.5 Maintenance and Service Guide - Page 71
Fingerprint reader, the fingerprint reader cable is connected to, and then disconnect
View all HP Dragonfly 13.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
1. Prepare the computer for disassembly (see Preparation for disassembly on page 48). 2. Remove the bottom cover (see Bottom cover on page 48). 3. Remove the battery (see Battery on page 50). Remove the fingerprint reader cable: 1. Detach the fingerprint reader cable (1) from the computer. The fingerprint reader cable is attached to the computer with double-sided tape. 2. Release the ZIF connector (2) the fingerprint reader cable is connected to, and then disconnect the fingerprint reader cable from the system board. 3. Release the ZIF connector (3) the fingerprint reader cable is connected to, and then disconnect the fingerprint reader cable (2) from the fingerprint reader extension cable. To install the fingerprint reader cable, reverse this procedure. Fingerprint reader To remove the fingerprint reader, use this procedure and illustration. Table 5-10 Fingerprint reader descriptions and part numbers Description Spare part number Fingerprint reader: NOTE: The fingerprint reader spare part kit does not include the fingerprint reader cable. The fingerprint reader cable is included in the Cable Kit, spare part number tbd-001. In natural silver finish N53653-001 In slate blue finish N53652-001 Before removing the fingerprint reader, follow these steps: Fingerprint reader 65