HP ENVY 13-ag0000 Maintenance and Service Guide - Page 57
Volume button, Push inward on the side of the button to disengage it from the computer
![]() |
View all HP ENVY 13-ag0000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Volume button Description Volume button Spare part number L28982-001 Before removing the volume button, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer. 4. Remove the bottom cover (see Bottom cover on page 25). 5. Remove the battery (see Battery on page 27). 6. Remove the system board (see System board on page 46). Remove the volume button: 1. Press the two legs in to release them from the clips in the computer (1). 2. Push inward on the side of the button to disengage it from the computer (2). NOTE: Be sure to press the side of the button (not the center). You can press either side of the button to release it. 3. Lift the disengaged side up to release the button from the computer (3). 4. Remove button from the computer (4). Reverse this procedure to install the volume button. Component replacement procedures 49
![](/manual_guide/products/hewlettpackard-envy-13ag0000-maintenance-service-guide-801743d/57.png)