HP ENVY 14-u000 ENVY 14 Notebook PC Maintenance and Service Guide - Page 68
Fan, the computer on, and then shut it down through the operating system.
View all HP ENVY 14-u000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
2. Remove the memory module (2) by pulling it away from the slot at a 45 degree angle. Fan Reverse this procedure to install the memory module. Description Fan Spare part number 763700-001 NOTE: To properly ventilate the computer, allow at least 7.6 cm (3 in) of clearance on the left side of the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature sensor and is designed to turn on automatically when high temperature conditions exist. These conditions are affected by high external temperatures, system power consumption, power management/battery conservation configurations, battery fast charging, and software requirements. Exhaust air is displaced through the ventilation grill located on the left side of the computer. Before removing the fan, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 31), and then remove the following components: a. Optical drive (see Optical drive on page 32) b. Top cover (see Top cover on page 39) c. Power connector cable (see Power connector cable on page 63) d. System board (see System board on page 52) 58 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts