HP ENVY 14t-u000 HP ENVY 14 Notebook PC Maintenance and Service Guide - Page 40
If it is necessary to replace the optical drive bracket and bezel
View all HP ENVY 14t-u000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 29). Remove the optical drive: 1. Using a small Phillips screwdriver, remove the Phillips M2.5×6.5 screw that secures the optical drive to the computer (1). 2. Pull the tray (2) out from the front until the optical drive is completely removed from the computer. If it is necessary to replace the optical drive bracket and bezel, position the optical drive with the rear panel toward you. 1. Remove the two Phillips screws from the optical drive (1) and remove the bracket (2). 30 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts