HP EliteBook 8570w HP EliteBook 8570w Mobile Workstation Maintenance and Servi - Page 110
ExpressCard/USB 2.0 assembly, Modem module see
View all HP EliteBook 8570w manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
ExpressCard/USB 2.0 assembly Description ExpressCard/USB 2.0 assembly Spare part number 652680-001 Before removing the ExpressCard/USB 2.0 assembly, follow these steps: IMPORTANT: Make special note of each screw and screw lock size and location during removal and replacement. 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 46). 5. Remove the service door (see Service door on page 52). 6. Remove the following components: a. Hard drive (see Hard drive on page 63). b. Upgrade bay device (see Upgrade bay device on page 68). c. Keyboard (see Keyboard on page 72). d. Top cover (see Top cover on page 76). e. Fan and heat sink assembly (see Fan and heat sink assembly on page 89). f. Processor (see Processor on page 93). g. Modem module (see Modem module on page 97). h. Audio/USB 3.0 board (see Audio/USB 3.0 board on page 95). i. Speakers (see Speakers on page 99). Remove the ExpressCard/USB 2.0 assembly: 1. Position the computer right-side up, with the front toward you. 2. Remove the SD and CFast slot protective inserts (1). 3. Remove the three Torx 8 screws (2) that secure the assembly to the system board. 102 Chapter 4 Removal and replacement procedures