HP EliteBook 8570w HP EliteBook 8570w Mobile Workstation Maintenance and Servi - Page 119
Power connector cable
View all HP EliteBook 8570w manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Power connector cable NOTE: The power connector cable is included in the cable kit, spare part number 690623-001. Before removing the power connector cable, follow these steps: IMPORTANT: Make special note of each screw and screw lock size and location during removal and replacement. 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 46). 5. Remove the service door (see Service door on page 52). 6. Remove the following components: a. Hard drive (see Hard drive on page 63). b. Upgrade bay device (see Upgrade bay device on page 68). c. Keyboard (see Keyboard on page 72). d. Top cover (see Top cover on page 76). e. Fan and heat sink assembly (see Fan and heat sink assembly on page 89). f. Audio/USB 3.0 board (see Audio/USB 3.0 board on page 95). g. Speakers (see Speakers on page 99). h. ExpressCard/USB 2.0 assembly (see ExpressCard/USB 2.0 assembly on page 102). i. System board (see System board on page 106). Remove the power connector cable: 1. Position the computer right-side up, with the front toward you. 2. Remove the tape (1) from the top of the power connector cable. 3. Lift the power connector cable (2) up from the routing in the rear of the base enclosure. Component replacement procedures 111