HP J4868A User Manual - Page 41

Switch Ports and Network, Cables, Other Wiring Rules

Get HP J4868A PDF manuals and user guides View all HP J4868A manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

Switch Ports and Network Cables Switch Ports and Network Cables Twisted-Pair Cable/Connector Pin-Outs Other Wiring Rules: I All twisted-pair wires used for 10 Mbps, and 100 Mbps operation must be twisted through the entire length of the cable. The wiring sequence must conform to EIA/TIA 568-B (not USOC). See the Pin Assignment tables below the cable illustrations later in this appendix for a listing of the signals used on each pin. I For 10 Mbps connections to the ports, you can use 100-ohm differential Category 3, 4, or 5 unshielded (UTP) or shielded (STP) twisted-pair cable, as supported by the IEEE 802.3 10Base-T standard. I For 100 Mbps connections to the ports, use 100-ohm differential Category 5 UTP or STP cable only, as supported by the IEEE 802.3u 100Base-TX standard. B-3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
B-3
Switch Ports and Network Cables
Twisted-Pair Cable/Connector Pin-Outs
Switch Ports and Network
Cables
Other Wiring Rules:
■
All twisted-pair wires used for 10 Mbps, and 100 Mbps operation must be
twisted through the entire length of the cable. The wiring sequence must
conform to EIA/TIA 568-B (not USOC). See the Pin Assignment tables
below the cable illustrations later in this appendix for a listing of the
signals used on each pin.
■
For 10 Mbps connections to the ports, you can use 100-ohm differential
Category 3, 4, or 5 unshielded (UTP) or shielded (STP) twisted-pair cable,
as supported by the IEEE 802.3 10Base-T standard.
■
For 100 Mbps connections to the ports, use 100-ohm differential Category
5 UTP or STP cable only, as supported by the IEEE 802.3u 100Base-TX
standard.