HP LH4r HP Netserver LH 3 Surestore E Installation Guide - Page 60

Install Controller Batteries

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 60 highlights

Install Controller Batteries The two battery packs included with the controller module must be installed before the controller module is installed in the disk array. 1. Remove the battery cover latch and then remove the RFI shield (if necessary, you can use a flat-bladed screwdriver to remove the RFI shield). 2. Install both battery packs, and connect the cables as shown in panel 4 of Figure 5. 3. Reinstall the RFI shield and the battery cover latch. CAUTION Make sure you reinstall the battery cover latch carefully, so each of the locking tabs (items 1 and 2 in panel 5 of Figure 5) slide beneath the battery compartment. If the battery cover latch is not secured properly, it could prevent the removal of the controller module once it is installed in the disk array enclosure. Figure 5. Installing Controller Batteries 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
10
Install Controller Batteries
The two battery packs included with the controller module must be installed before the controller module is
installed in the disk array.
1.
Remove the battery cover latch and then remove the RFI shield (if necessary, you can use a flat-bladed
screwdriver to remove the RFI shield).
2.
Install both battery packs, and connect the cables as shown in panel 4 of Figure 5.
3.
Reinstall the RFI shield and the battery cover latch.
CAUTION
Make sure you reinstall the battery cover latch carefully, so each of the locking tabs
(items 1 and 2 in panel 5 of Figure 5) slide beneath the battery compartment. If the
battery cover latch is not secured properly, it could prevent the removal of the controller
module once it is installed in the disk array enclosure.
Figure 5. Installing Controller Batteries