HP LaserJet 9000 Service Manual - Page 88
Theory of operation, Table 15., Failure sequence of operation, State, Period, Operation
View all HP LaserJet 9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Table 14. Normal sequence of operation (continued) State Period Operation INTR (initial rotation) PRINT LSTR (last rotation) From the input of a print- z reservation command from the z formatter until the laser/scanner z enters a ready state z z z z z z z z From the input of a print z command until the primary dc z bias is turned off z z z z z z z From the time the primary z charging roller is turned off until z each of the motors stops z z z z z scanner-motor rotation fuser/delivery-motor rotation drum-motor rotation high-voltage control (negative bias to transfer roller) receives print command fan-motors 1 through 6 full-speed rotation pickup operation starts high-voltage control bias applied to primary charging roller, developing roller, and transfer roller) fuser control (fuser roller to 190°C [374 °F], pressure roller 180°C [356°F]) initial rotation final check (high-voltage, scanner motor, pickup operation complete) jam/door open/failure/sleep check fuser/delivery, drum, scanner, and fan-motor rotations fuser control (print temperature-fuser 190°C [374°F]) engine-to-formatter output signal formatter-to-engine input signal paper-feed control image control high-voltage control (toner level-output separation bias and pressure roller bias) next-pickup control (calculates, from media size, the speed to send media through) jam/door open/failure fuser/delivery, drum, scanner, and fan motor rotations high-voltage control completion fuser control (print to standby temperature-180°C [356°F]) fan motor control (fan 1 through 6 full-speed rotation) fuser/delivery, drum, and scanner motor stop (writes in cartridge memory) jam/door open/failure check ready for next pickup Table 15. Failure sequence of operation State Period Operation JAM From the time the power is z sensor check switched on until the end of the z drive stop (scanner motor, high-voltage, fuser control, and LSTR period fuser/delivery motor stop) z status setting (jam status set) z door open check DOOR OPEN From the time the power is z switched on until the end of the z LSTR period z drive stop status setting door close (wait sequence) FAILURE From the time the power is z drive stop switched on until the end of the z status setting (set) LSTR period 72 Chapter 5 Theory of operation