HP M5035x HP LaserJet M5025/M5035 MFP - User Guide - Page 241
Solve common Macintosh problems, device will
UPC - 882780574830
View all HP M5035x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 241 highlights
Solve common Macintosh problems In addition to the problems that are listed in Solve general printing problems, this section lists problems that can occur when using Mac OS X. NOTE Setup for USB and IP printing is performed through the Desktop Printer Utility. The device will not appear in the Chooser. The printer driver is not listed in the Print Center or Printer Setup Utility. Cause Solution The device software might not have been installed or was installed incorrectly. Make sure that the PPD is in the following hard drive folder: Library/Printers/PPDs/Contents/Resources/ .lproj, where "" represents the two-letter language code for the language that you are using. If necessary, reinstall the software. See the getting started guide for instructions. The Postscript Printer Description (PPD) file is corrupt. Delete the PPD file from the following hard drive folder: Library/ Printers/PPDs/Contents/Resources/.lproj, where "" represents the two-letter language code for the language that you are using. Reinstall the software. See the getting started guide for instructions. The device name, IP address, or Rendezvous host name does not appear in the printer list in the Print Center or Printer Setup Utility. Cause Solution The device might not be ready. The wrong connection type might be selected. The wrong device name, IP address, or Rendezvous host name is being used. The interface cable might be defective or of poor quality. Make sure that the cables are connected correctly, the device is on, and the Ready light is on. If you are connecting through a USB or Ethernet hub, try connecting directly to the computer, or use a different port. Make sure that USB, IP Printing, or Rendezvous is selected, depending on the type of connection that exists between the device and the computer. Check the device name, IP address, or Rendezvous host name by printing a configuration page. See Use information pages. Verify that the name, IP address, or Rendezvous host name on the configuration page matches the device name, IP address, or Rendezvous host name in the Print Center or Printer Setup Utility. Replace the interface cable. Make sure to use a high-quality cable. The printer driver does not automatically set up the selected device in the Print Center or Printer Setup Utility. Cause Solution The device might not be ready. Make sure that the cables are connected correctly, the device is on, and the Ready light is on. If you are connecting through a USB or Ethernet hub, try connecting directly to the computer or use a different port. The device software might not have been installed or was installed incorrectly. Make sure that the PPD file is in the following hard drive folder: Library/Printers/PPDs/Contents/Resources/ .lproj, where "" represents the two-letter language ENWW Solve common Macintosh problems 229