HP M5035x HP LaserJet M5025/M5035 MFP - User Guide - Page 53
Table 2-11, Menu item, Sub-menu item, Values, Description
UPC - 882780574830
View all HP M5035x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Table 2-11 Fax Setup menu (continued) Menu item Sub-menu item Sub-menu item Fax Send Settings Fax Dial Volume Error Correction Mode JBIG Compression Maximum Baud Rate Dialing Mode Redial On Busy Redial On No Answer Redial Interval Detect Dial Tone Dialing Prefix Billing Codes Minimum Length Values Description Off Medium (default) Use this feature to set the volume of the tones that you hear while the device dials the fax number. High Enabled (default) Disabled When Error Correction Mode is enabled and an error occurs during fax transmission, the device sends or receives the error portion again. Disabled Enabled (default) The JBIG Compression reduces faxtransmission time, which can result in lower phone charges. However, using JBIG Compression sometimes causes compatibility problems with older fax machines. If this occurs, turn off the JBIG Compression. Select a value from the list. Use this feature to set the maximum baud rate for receiving faxes. This can be used as a diagnostic tool for troubleshooting fax problems. Tone (default) Pulse Select whether the device should use tone or pulse dialing. The range is between Type the number of times the device should 0 and 9. The factory attempt to redial if the line is busy. default is 3 times. Never (default) Once Use this feature to specify the number of times the device should attempt to dial if the recipient fax number does not answer. Twice NOTE Twice is available in locations other than the United States and Canada. The range is between 1 and 5 minutes. The factory default is 5 minutes. Use this feature to specify the number of minutes between dialing attempts if the recipient number is busy or not answering. Enabled Disabled (default) Use this feature to specify whether the device should check for a dial tone before sending a fax. Off (default) Custom Use this feature to specify a prefix number that must be dialed when sending faxes from the device. Off (default) Custom When billing codes are enabled, a prompt appears that asks the user to enter the billing code for an outgoing fax. The range is between 1 and 16 digits. The default is 1 digit. ENWW Use the Administration menu 41