HP Model 744 HP Model 744 Owner's Guide - Page 51
GSC Mezzanine Cards, Installing GSC Mezzanine Cards, Preliminary Requirements
View all HP Model 744 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Installing Accessories GSC Mezzanine Cards GSC Mezzanine Cards Installing GSC Mezzanine Cards This section provides step-by-step instructions for installing GSC mezzanine cards into your Model 744 Board Computer. Preliminary Requirements Perform the following steps before you install a GSC card: 1 The Model 744 Board Computer must already have a GSC expansion kit installed. 2 If the Model 744 Board Computer is already installed in your system chassis, you must remove it. See Chapter 3 of this manual for instructions on removing and replacing the Model 744. 3 Place the Model 744 Board Computer on a static-free mat on a clean, level surface. GSC Mezzanine Card Installation Follow these steps to install a GSC card onto your Model 744 Board Computer: 1 Working from the back of the Model 744 Board Computer, you can install GSC graphics cards into either the right-hand or center position, shown in Figure 2-4. 2 Using Figure 2-4 as a guide, position a card and line up its connector over the GSC connector on the board computer. 3 Press the card down to seat the connectors. 4 Insert the two M2.5x6 screws that hold the GSC card to the adapter fixture and screw them into place. 5 Insert the two M2.5x5 screws that hold the card to the front panel expansion plate and screw them into place. 2-11