HP Model 744 HP Model 744 Owner's Guide - Page 78
Model 744 Removal, Tools Required, Preliminary Requirements, Removing a Model 744
View all HP Model 744 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Typical Installation in a VME Card Cage Model 744 Removal Model 744 Removal Tools Required Model 744 removal requires the following tools: Tool Static grounding wrist strap Light-duty flat-tipped screwdriver Used For Preventing static discharge problems Loosening card cage screws Preliminary Requirements Perform the following procedure before you remove the board computer from the VME card cage: 1 Read the steps in "Turning Off the System," in Chapter 5. Removing a Model 744 Follow these steps to remove the Model 744 from a VME card cage: 1 Loosen the captive screws at each end of the board computer that hold the computer in the VME card cage (in Figure 3-3, the screws are labeled 1 and 2 for a single-slot board computer, or 1 through 4 for a dual-slot board computer). 2 Pull both ejector levers out until the board ejects from the card cage. 3-12