HP Model 744 HP Model 744 Owner's Guide - Page 87
Power Cord, Connecting a Terminal, your Model 744 Board Computer. Refer
View all HP Model 744 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Connecting Cables Connecting a Single Monitor, Multi-Display System, or Text-Only Terminal WARNING: NOTE: Power Cord If your monitor has an attached power cord, connect the plug to a power source. If your monitor has a separate cord, connect the cord to the monitor, then connect the plug to a power source. Do not connect your monitor to a power extension strip. Doing so can cause a shock hazard. Do not turn on your monitor at this time. NOTE: Connecting a Terminal This section provides step-by-step instructions for connecting a terminal to your Model 744 Board Computer. Refer to Figure 4-3. 1 Using the HP A4301A conversion RS-232C Cable, plug its micro-miniature connector to one of the RS-232 connectors as follows: • The recommended port for connecting a terminal is the (A) port. • Using the (B) port for terminal connection is not recommended. Use of the (B) port requires that VME Services software be installed in the kernel under HP-UX. The (B) port is not supported during "cold installs" of HP-UX because VME Services is not installed in the "install kernel". RS-232 (A) Figure 4-3 RS-232 (B) Connecting a Terminal to the RS-232 Ports 2 Plug the standard end of the conversion cable into the appropriate connec- tor of RS-232 serial cable HP 24525G. 4-7