HP Model 744 HP Model 744 Owner's Guide - Page 58
Installing a PMC Card onto the Expansion Adapter, remains in place.
View all HP Model 744 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
NOTE: Installing Accessories PMC Bridge Adapter and Expansion Adapter 6 If you are installing the PMC expansion adapter, refer to your third party PMC card installation manual, and set any configuration switches or jumpers that may be required for your application. 7 On the PMC expansion adapter, remove the bezel blank(s) from the sites where you will be installing the PMC card(s). See Figure 2-8. When installing a PMC card, ensure that the O-ring type gasket near the bezel remains in place. 8 Install the PMC card(s) onto the expansion adapter by aligning the front of the card with the front bezel, and onto the rear of the card with the connectors and post. See Figure 2-8. O-Ring Gasket Bezel blank PMC Card Site 4 Site 3 Expansion Adapter Figure 2-8 2-18 Installing a PMC Card onto the Expansion Adapter