HP NetServer LXr Pro8 HP Netserver Mass Storage Upgrade Guide - Page 20

To attach the 68-pin connector, press on the center of the connector strain

Get HP NetServer LXr Pro8 PDF manuals and user guides View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Chapter 2 Installation 2. Connect the SCSI cable's 68-pin connector labeled "To I/O Board" to the SCSI B connector on the I/O baseboard, as shown in Figure 2-6. To attach the 68-pin connector, press on the center of the connector strain relief and press the connector into place, as shown in Figure 2-7. Two clicks indicates the connector is properly installed. Figure 2-7. Attach SCSI Cable Connector 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Chapter 2
Installation
16
2.
Connect the SCSI cable’s 68-pin connector labeled "To I/O Board" to the
SCSI B connector on the I/O baseboard, as shown in Figure 2-6.
To attach the 68-pin connector, press on the center of the connector strain
relief and press the connector into place, as shown in Figure 2-7. Two
clicks indicates the connector is properly installed.
Figure 2-7. Attach SCSI Cable Connector