HP NetServer LXr Pro8 HP Netserver Mass Storage Upgrade Guide - Page 25
HP NetServer Duplex, Kit Installation Guide
View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 2 Installation Before you install the hot-swap disk drive modules, decide where to place them in the secondary mass storage cage. Figure 2-11 shows the drive blockers, which prevent installation of drive modules into unsupported positions. Drive Blockers prevent installation of drive modules into unsupported positions Figure 2-11. Drive Blockers in Hot-Swap Mass Storage Cage NOTE SCSI addresses (IDs) in the secondary hot-swap mass storage cage are different from and independent of SCSI addresses in the primary cage. SCSI addresses for devices in both cages for single-bus and dual-bus configurations are shown in your HP NetServer installation guide and the HP NetServer Duplex Kit Installation Guide. 21
Chapter 2
Installation
21
Before you install the hot-swap disk drive modules, decide where to place them in
the secondary mass storage cage. Figure 2-11 shows the drive blockers, which
prevent installation of drive modules into unsupported positions.
Drive Blockers
prevent installation
of drive modules into
unsupported positions
Figure 2-11.
Drive Blockers in Hot-Swap Mass Storage Cage
NOTE
SCSI addresses (IDs) in the secondary hot-swap mass storage
cage are different from and independent of SCSI addresses in
the primary cage. SCSI addresses for devices in both cages for
single-bus and dual-bus configurations are shown in your
HP NetServer installation guide and the
HP NetServer Duplex
Kit Installation Guide
.