HP NetServer LXr Pro8 HP Netserver Mass Storage Upgrade Guide - Page 29
Step 12, Verify Installation
View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Chapter 2 Installation Step 12: Verify Installation Verify the installation of the second hot-swap mass storage cage and the drives in it. To do so, verify that all of the hot-swap drives are operational by using one of the following: l Hard disk drive LEDs: See "Verifying Hard Disk Drive Operation" below. l HP DiagTools: Run this diagnostic utility to verify the hard disk drive modules. Refer to your HP NetServer's installation guide, or download HP DiagTools and its guide. To download, go to http://www.hp.com/go/netserver/, select Technical Support, and then select Troubleshooting. Download the latest version of HP DiagTools and the guide for it. Verifying Hard Disk Drive Operation Each Ultra2 hard disk drive module has two LED indicators on its front, one for status and one for activity, as shown in Figure 2-14. Status LED Indicator Activity LED Indicator Figure 2-14. LED Apertures on Ultra 2 Hard Disk Drive Module 25