HP NetServer LXr Pro8 HP Netserver Mass Storage Upgrade Guide - Page 22
Step 7, Connect Power Harness
View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Chapter 2 Installation Step 7: Connect Power Harness 1. Orient the connector labeled P2 on the power harness to the power socket on the backplane of the mass storage cage, as shown in Figure 2-9. Figure 2-9. Connect Power Harness to Backplane of Mass Storage Cage 2. Connect the P2 connector on the power harness to the power socket on the backplane of the mass storage cage. Verify that the latch on the connector is seated. 18
Chapter 2
Installation
18
Step 7:
Connect Power Harness
1.
Orient the connector labeled P2 on the power harness to the power socket
on the backplane of the mass storage cage, as shown in
Figure 2-9.
Figure 2-9. Connect Power Harness to Backplane of Mass Storage Cage
2.
Connect the P2 connector on the power harness to the power socket on the
backplane of the mass storage cage. Verify that the latch on the connector
is seated.