HP Pavilion 17-ar000 Maintenance and Service Guide - Page 34

from the keyboard/top cover., Separate the rear edge of the bottom cover

Get HP Pavilion 17-ar000 PDF manuals and user guides View all HP Pavilion 17-ar000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

2. Remove the following screws that secure the bottom cover to the computer: (2) Two Phillips M2.5×6.7 screws under the rear rubber feet (3) Three Phillips PM2.0×10.8 screws rear edge and middle of computer (4) Three Phillips M2.0×5.7 screws on the front edge (5) Four Phillips M2.0×2.8 broad head screws in the optical drive bay 3. Insert a case utility tool (1) or similar thin, plastic tool into the display hinge areas of the bottom cover. 4. Separate the rear edge of the bottom cover (2 from the keyboard/top cover. 5. Separate the tabs (3) built into the keyboard/top cover from the slots built into the bottom cover. 6. Remove the bottom cover (4). Reverse this procedure to install the bottom cover. 26 Chapter 5 Removal and replacement procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
2.
Remove the following screws that secure the bottom cover to the computer:
(2)
Two Phillips M2.5×6.7 screws under the rear rubber feet
(3)
Three Phillips PM2.0×10.8 screws rear edge and middle of computer
(4)
Three Phillips M2.0×5.7 screws on the front edge
(5)
Four Phillips M2.0×2.8 broad head screws in the optical drive bay
3.
Insert a case utility tool
(1)
or similar thin, plastic tool into the display hinge areas of the bottom cover.
4.
Separate the rear edge of the bottom cover
(2
from the keyboard/top cover.
5.
Separate the tabs
(3)
built into the keyboard/top cover from the slots built into the bottom cover.
6.
Remove the bottom cover
(4)
.
Reverse this procedure to install the bottom cover.
26
Chapter 5
Removal and replacement procedures