HP ProDesk 480 G7 PCI Micro Maintenance and Service Guide - Page 45
Solid-state drive, Store the removed card in antistatic packaging.
View all HP ProDesk 480 G7 PCI Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
To remove an expansion card: 1. Remove the Phillips screw (1) that secures the expansion card bracket to the expansion card. 2. Release the expansion card bracket (2) from the expansion card. 3. Release the slot cover retention latch (3) that secures the slot covers by lifting the tab on the latch and rotating the latch to the open position. 4. Pull the retention arm (4) on the back of the expansion socket away from the expansion card and carefully rock the card back and forth until the connectors pull free from the socket. 5. Lift the expansion card (5) straight up and then away from the inside of the system chassis to remove it. Be sure not to contact the card against other components. 6. Store the removed card in antistatic packaging. 7. If you are not installing a new expansion card, install an expansion slot cover to close the open slot. CAUTION: After removing an expansion card, you must replace it with a new card or expansion slot cover for proper cooling of internal components during operation. 8. Reassemble and reconfigure the computer, if necessary. Solid-state drive To remove the solid-state drive module, use these procedures. Table 4-4 Solid-state drive descriptions Description M.2 2280 solid-state drive: 2 TB, M.2 2280, peripheral component interconnect express (PCIe), non-volatile memory express (NVMe), Secure Seal (SS) solid-state drive with triple level cell (TLC) 1 TB, M.2 2280, PCIe, NVMe, SS solid-state drive with TLC 512 GB, M.2 2280, PCIe, NVMe, SS solid-state drive with TLC ENWW Solid-state drive 37