HP ProLiant 8500 ProLiant 8500 Servers Maintenance and Service Guide - Page 101
Array Drive Failure., The following SCSI
View all HP ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Diagnostic Tools 3-23 Table 3-2 POST Error Messages continued Error Code Audible Beeps 1779-Slot X Drive None Array - Replacement drive(s) detected OR previously failed drive(s) now operational: Port Y: SCSI ID Z: Restore data from backup if replacement drive X has been installed. 1780-Disk 0 Failure None 1781-Disk 1 Failure None 1782-Disk Controller None Failure 1783-Slot X Drive None Array Controller Failure. 1784-Slot X Drive None Array Drive Failure. The following SCSI drive(s) should be replaced: SCSI Port Y: SCSI ID Z: Probable Source of Problem Intermittent drive failure or possible loss of data detected. Recommended Action If this message displays and drive X has not been replaced, there may be an intermittent drive failure. This message also displays immediately following drive replacement whenever data must be restored from backup. Hard drive/format error detected. Hard drive/format error detected. Hard disk drive circuitry error detected. ROM installation problem or array accelerator board problem detected. Defective drive and/or cables detected. Run Compaq Diagnostics. Replace failed assembly as indicated. Run Compaq Diagnostics. Replace failed assembly as indicated. Run Compaq Diagnostics. Replace failed assembly as indicated. If this message displays immediately following a ROM installation, if the ROM is defective or not installed properly. Check to see if the array accelerator board is attached properly. Check that the array controller is firmly inserted in its slot. Try upgrading the System ROM. Otherwise, replace the Smart Array Controller. Check for loose cables. Replace defective drive X and/or cable(s). continued