HP ProLiant 8500 ProLiant 8500 Servers Maintenance and Service Guide - Page 88
Run Diagnostics. Replace failed, Single Bits Errors
View all HP ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
3-10 Compaq ProLiant 8500 Server Maintenance and Service Guide Table 3-2 POST Error Messages continued Error Code Audible Beeps 180-Log Reinitialized None 201-Memory Error 202-Memory Type Mismatch None 2 short 203-Memory Address Error 207-ECC Corrected Single Bits Errors in DIMM in Memory Module Socket 207-Invalid Memory Configuration Check DIMM Installation 208-Invalid Memory Speed - Check DIMM Installation 209-Memory Detection Failure Check Memory Installation 211 Invalid Voltage Regulator Module installed for Processor X 212-System Processor Failed/ Mapped out 214-Processor PPM Failed Module X 215-Non-functioning Voltage Regulator Module for Processors None 2 short None 1 long, 1 short 1 long, 1 short None 1 short None None Probable Source of Problem The Integrated Management Log has been reinitialized, probably due to corruption of the log. RAM failure detected An incompatible memory module is installed in the system. RAM failure detected A memory module is malfunctioning. Memory module installed incorrectly Recommended Action Event message, no action needed. Run Diagnostics. Replace failed assembly as indicated. Compare Compaq part numbers from installed memory modules with the manual. If not listed, the memory modules are incompatible and should be replaced or removed. Run Diagnostics. Replace failed assembly as indicated. Run Compaq Diagnostics. Replace or remove malfunctioning memory module as indicated. Verify placement of memory modules. The speed of the memory is not compatible. Unable to size memory Non-redundant Processor Power Module (PPM) installed in indicated processor slot. Verify the speed of the memory modules installed, then check your server user documentation and replace as indicated. Check memory module installation. If error persists, call Compaq authorized service provider. Replace with a PPM that supports redundancy. Processor in slot X failed Run Compaq Diagnostics and replace failed processor. Indicated Processor Power Module (PPM) failed. Indicated Processor Power Module PPM (DC-DC Converter) has failed or lost redundancy. Replace failed PPM assembly as indicated. Run Compaq Diagnostics. Replace failed assembly if necessary continued