HP Scanjet 9000 User Guide - Page 112
Link speed and duplex settings, 100TX Full
View all HP Scanjet 9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
● TCP/IP ● IPV6 Settings 3. Select Enable, select On, and then select OK. 4. To configure the address, open the Manual Settings menu, and then select Address. 5. Use the keypad to enter the address, and then select OK. Link speed and duplex settings NOTE: This information applies only to Ethernet networks. It does not apply to wireless networks. The link speed and communication mode of the scan server must match the network hub. For most situations, leave the product in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the product from communicating with other network devices. To make changes, use the product control panel. NOTE: The product setting must match the setting for the network device (a network hub, switch, gateway, router, or computer). NOTE: Making changes to these settings causes the product to turn off and then on. Make changes only when the product is idle. 1. From the Home screen on the product control panel, swipe until the Settings menu displays. Touch the Settings icon to open the menu. 2. Open the following menus: ● Networking ● Ethernet ● Link Speed 3. Select one of the following options: ● Auto: The scan server automatically configures itself for the highest link speed and communication mode allowed on the network. ● 10T Half: 10 megabytes per second (Mbps), half-duplex operation ● 10T Full: 10 Mbps, full-duplex operation ● 10T Auto: 10 Mbps, automatic-duplex operation ● 100TX Half: 100 Mbps, half-duplex operation ● 100TX Full: 100 Mbps, full-duplex operation ● 100TX Auto: 100 Mbps, automatic-duplex operation ● 1000T Full: 1000 Mbps, full-duplex operation 4. Select OK. 102 Chapter 4 Manage the scanner ENWW