HP StorageWorks 2000s NAS 2000s Install Guide - Page 21
Procedure
View all HP StorageWorks 2000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Procedure To initialize the NAS 2000s: Caution: Do not power up the NAS device until steps 1 through 5 are completed. 1. Connect the Ethernet cables to the respective network ports of the NAS 2000s and the corresponding network segments. See Figure 3 and Table 2 on page 14 for the locations of the network ports on the NAS 2000s. Note: Connect a loopback cable to any of the NAS 2000s Ethernet ports that are not configured for use. 2. Verify that the Windows-based PC client is connected to the same subnet as the NAS 2000s. 3. Power on the PC and wait until the operating system has completely loaded. 4. Insert the RapidLaunch CD into the CD-ROM drive of the PC. 5. The RapidLaunch CD should run automatically. If the program does not start up automatically, the program may be run manually. Click Start, select Run on the Windows taskbar, and then type the following: {CD ROM drive}:\setup.exe Wait for the interface to start. 6. Go to the NAS device and power it on. It will be several minutes before the NAS device is accessible on the network. 7. Return to the PC. Select StorageWorks NAS from the Show drop-down list to have RapidLaunch list all NAS devices on the network, as shown in Figure 4. NAS 2000s Installation Guide 21