HP StorageWorks 2000s NAS 2000s Install Guide - Page 25

Enter, Security Alert, Procedure

Get HP StorageWorks 2000s - NAS PDF manuals and user guides View all HP StorageWorks 2000s manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Procedure To initialize the NAS 2000s: 1. Connect the Ethernet cables to the respective network ports of the NAS 2000s and the corresponding network segments. See Figure 3 and Table 2 on page 14 for the locations of the network ports on the NAS 2000s. 2. Go to the NAS device and power it on. It will be several minutes before the NAS device is accessible on the network. Note: The NAS device will respond when the NAS operating system has started. 3. Open Internet Explorer on the PC. Enter https://, the serial number of the NAS 2000s followed by a hyphen (-), and then :3202. Press Enter. Example: https://D4059ABC3433-:3202 Note: Substitute the server name for the serial number if a server name was previously set. 4. Click Yes in the Security Alert dialog to accept the security certificate. 5. Login to the WebUI. This launches the WebUI configuration application (Rapid Startup) on the target HP StorageWorks NAS device, as shown in Figure 7. Note: The default login for the WebUI is administrator and the password is hpinvent. The WebUI uses the same login as the local administrator's account or an account with administrative privileges. 6. Go to the next section "Rapid Startup Wizard Configuration," to complete the setup procedures. NAS 2000s Installation Guide 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
NAS 2000s Installation Guide
25
Procedure
To initialize the NAS 2000s:
1.
Connect the Ethernet cables to the respective network ports
of the NAS 2000s and the corresponding network segments.
See
Figure 3
and
Table 2
on page 14 for the locations of the
network ports on the NAS 2000s.
2.
Go to the NAS device and power it on. It will be several
minutes before the NAS device is accessible on the network.
Note:
The NAS device will respond when the NAS operating system
has started.
3.
Open Internet Explorer on the PC. Enter
https://
, the
serial number of the NAS 2000s followed by a hyphen (-),
and then
:3202
. Press
Enter
.
Example:
https://D4059ABC3433-:3202
Note:
Substitute the server name for the serial number if a server
name was previously set.
4.
Click
Yes
in the
Security Alert
dialog to accept the security
certificate.
5.
Login to the WebUI. This launches the WebUI configuration
application (Rapid Startup) on the target HP StorageWorks
NAS device, as shown in
Figure 7
.
Note:
The default login for the WebUI is
administrator
and the
password is
hpinvent
. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
6.
Go to the next section “
Rapid Startup Wizard Configuration
,”
to complete the setup procedures.