HP StorageWorks 2000s NAS 2000s Install Guide - Page 26

Direct Attach Method, Procedure

Get HP StorageWorks 2000s - NAS PDF manuals and user guides View all HP StorageWorks 2000s manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

Direct Attach Method You can access the WebUI using a monitor, mouse, and keyboard directly attached to the NAS 2000s. Procedure To initialize the NAS 2000s: 1. Connect the Ethernet cables to the respective network ports of the NAS 2000s and the corresponding network segments. 2. Connect the monitor, mouse, and keyboard directly to the rear panel connectors of the NAS 2000s. See Figure 3 and Table 2 on page 14 for the locations of the connectors on the NAS 2000s. 3. Open Internet Explorer and click Yes in the Security Alert dialog to accept the security certificate. This launches the WebUI configuration application (Rapid Startup) on the target StorageWorks NAS device, as shown in Figure 7. If the WebUI does not launch connect to the LocalHost and login to the WebUI. Note: The default login for the WebUI is administrator and the password is hpinvent. The WebUI uses the same login as the local administrator's account or an account with administrative privileges. 4. Go to the "Rapid Startup Wizard Configuration" on page 27 to complete the setup procedures. 26 NAS 2000s Installation Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
26
NAS 2000s Installation Guide
Direct Attach Method
You can access the WebUI using a monitor, mouse, and keyboard
directly attached to the NAS 2000s.
Procedure
To initialize the NAS 2000s:
1.
Connect the Ethernet cables to the respective network ports
of the NAS 2000s and the corresponding network segments.
2.
Connect the monitor, mouse, and keyboard directly to the rear
panel connectors of the NAS 2000s. See
Figure 3
and
Table 2
on page 14 for the locations of the connectors on the NAS
2000s.
3.
Open Internet Explorer and click
Yes
in the
Security Alert
dialog to accept the security certificate. This launches the
WebUI configuration application (Rapid Startup) on the
target StorageWorks NAS device, as shown in
Figure 7
. If the
WebUI does not launch connect to the
LocalHost
and login to
the WebUI.
Note:
The default login for the WebUI is
administrator
and the
password is
hpinvent
. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
4.
Go to the “
Rapid Startup Wizard Configuration
” on page 27
to complete the setup procedures.