HP StorageWorks 2000s NAS 2000s Install Guide - Page 28

Procedure, Con the iLO System Information. Set the IP Address

Get HP StorageWorks 2000s - NAS PDF manuals and user guides View all HP StorageWorks 2000s manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Procedure Using the information from Table 3, fill in the screens that follow. 1. Select Next to start the Rapid Startup Wizard (There may be a slight pause because the wizard is gathering information about the system and populating the fields.) 2. Configure the Date and Time Settings. Select Next to continue. 3. Configure the Administrator Account settings. Select Next to continue. 4. Configure the Alert Email settings. Select Next to continue. 5. Configure the SNMP Settings. Select Next to continue. 6. Configure the iLO System Information. Set the IP Address to DHCP and set the iLO hostname. Do not modify the administrator account name. Select Next to continue. 7. Configure the Network Interface Information for both NICs. Select Next to continue. 8. Configure the System Information. Select Next to continue. 9. Verify that your information is correct when the configuration review screen is displayed as shown in Figure 8. 28 NAS 2000s Installation Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
28
NAS 2000s Installation Guide
Procedure
Using the information from
Table 3
, fill in the screens that follow.
1.
Select
Next
to start the Rapid Startup Wizard (There may be
a slight pause because the wizard is gathering information
about the system and populating the fields.)
2.
Configure the Date and Time Settings. Select
Next
to
continue.
3.
Configure the Administrator Account settings. Select
Next
to
continue.
4.
Configure the Alert Email settings. Select
Next
to continue.
5.
Configure the SNMP Settings. Select
Next
to continue.
6.
Configure the iLO System Information. Set the IP Address to
DHCP and set the iLO hostname. Do not modify the
administrator account name. Select
Next
to continue.
7.
Configure the Network Interface Information for both NICs.
Select
Next
to continue.
8.
Configure the System Information. Select
Next
to continue.
9.
Verify that your information is correct when the configuration
review screen is displayed as shown in
Figure 8
.