HP StorageWorks 4/256 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-0 - Page 121
AUTH-1043, Check the SFP and the cable. Then try to enable the port using
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
AUTH-1043 4 If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1043 Message , [AUTH-1043], ,, ERROR, , Failed to enforce device authentication mode:(error: ). Probable Cause Indicates that the Kernel mode setting for F_Port authentication failed. Device authentication will be defaulted to OFF, and switch will not participate in Diffie Hellman - challenge handshake authentication protocol (DH-CHAP) authentication with devices. Recommended Try setting the device authentication policy manually using the authUtil command. Action Severity ERROR AUTH-1044 Message , [AUTH-1044], ,, ERROR, , Authentication . Disabling port . Probable Cause Indicates authentication has timed out after multiple retries. The specified port has been disabled as a result. This problem may be transient due to the system's central processing unit (CPU) load. In addition, a defective small form-factor pluggable (SFP) or faulty cable may have caused the failure. Recommended Check the SFP and the cable. Then try to enable the port using the portEnable command. Action Severity ERROR AUTH-1045 Message , [AUTH-1045], ,, ERROR, , Certificate not present in this switch in port . Probable Cause Indicates that the public key infrastructure (PKI) certificate is not installed in this switch. Recommended Action Check the certificate availability using the pkiShow command. Install the certificate and reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. Severity ERROR Fabric OS Message Reference 51 53-1001338-01