HP StorageWorks 4/256 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-0 - Page 622
SEC-1329, SEC-1330, SEC-1331, SEC-1332
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 622 highlights
90 SEC-1329 SEC-1329 Message , [SEC-1329], ,, ERROR, , IPFilter enforcement: Failed to enforce ipfilter policy of type because of . Probable Cause Indicates the IP filter policy enforcement failed due to internal system failure. Recommended Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command Action and contact your switch service provider. Severity ERROR SEC-1330 Message , [SEC-1330], ,, ERROR, , command failed - db(s) are coming from a non-Primary switch. Probable Cause Indicates an attempt was made to distribute databases either from a backup fabric configuration server (FCS) switch or from a non-FCS switch. Recommended Verify the distribution is initiated by the primary FCS switch. Use the secPolicyShow command to Action verify and correct the configuration if necessary. Severity ERROR SEC-1331 Message , [SEC-1331], ,, ERROR, , Attempt to enable secure mode failed. Reason: . Probable Cause Indicates the secModeEnable command failed on the fabric because default IP Filter policies are not active on the switch, or an active transaction exists on IP Filter policies. Recommended Action Verify the security event was planned. If the security event was planned, run the ipfilter --activate default_ipv4 or the ipfilter --activate default_ipv6 command to activate default IP Filter Policies. Use the ipfilter --save or the ipfilter --transabort commands to save or abort any active transaction on IP Filter policies. Then retry the secModeEnable command. Severity ERROR SEC-1332 Message Probable Cause , [SEC-1332], ,, ERROR, , Fabric wide policy is conflicting as is present in the fabric wide policy and 5.3 or 5.2 switches present in the fabric. Indicates the fabric-wide policy is conflicting. 552 Fabric OS Message Reference 53-1001338-01