HP StorageWorks 8/40 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 224
EM-1045, Probable Cause, Recommended, Action, switchStart, Severity, Message, lscfg
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 224 highlights
22 EM-1045 Probable Cause Indicates that the specified field-replaceable unit (FRU) cannot be powered on because the associated logical switch is shut down. Recommended Run the switchStart command on the associated logical switch. Action Severity WARNING EM-1045 Message , [EM-1045], ,, WARNING, , is being powered . Probable Cause Indicates that an automatic power adjustment is being made because of the (predicted) failure of a power supply or the insertion or removal of a port blade. If new_state is On, a port blade is being powered on because more power is available (either a power supply was inserted or a port blade was removed or powered down). If new_state is Off, a port blade has been powered down because a power supply has been faulted, because it is indicating a predicted failure. If new_state is Down (not enough power), a newly inserted port blade was not powered on because there was not enough power available. Recommended The Brocade 24000 requires only a single power supply for a fully populated chassis; however, you Action should always operate the system with at least two power supplies for redundancy. Severity WARNING EM-1046 Message , [EM-1046], ,, WARNING, , Sysctrl reports error status for blade ID for the blade in slot Probable Cause Indicates that the blade specified is incompatible. Recommended Action If the blade ID listed is not correct, then the field-replaceable unit (FRU) header for the blade is corrupted and the blade must be replaced. If the reason is due to platform, the blade ID listed is not supported for that platform (CP) type. Remove the blade from the chassis. If the reason is due to backplane, the CP type (CP256) is not supported on that chassis (backplane revision D2), remove the blade from the chassis. If the reason is switch configuration, the blade's logical switch configuration is not correct. Run the lscfg command to correct the switch or port configuration for the ports on that blade. Severity WARNING EM-1047 Message , [EM-1047], ,, INFO, , CP in slot not faulty, CP ERROR deasserted. 154 Fabric OS Message Reference 53-1001338-01