HP StorageWorks 8/40 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 254
FABS-1005, Message, Probable Cause, Recommended, Action, firmwareDownload, Severity
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
27 FABS-1005 FABS-1005 Message , [FABS-1005], ,, WARNING, , (= ) Probable Cause Indicates that an unsupported operation has been requested. This is usually an internal Fabric OS problem or file corruption. The possible value for function name and description of problem is: fabsys_write: Unsupported write operation: process xxx where xxx is the process ID (PID), which could be any whole number. Recommended Action Reboot or power cycle the active CP (for modular systems) or the switch (for single-board systems). If the message persists, run the firmwareDownload command to update the firmware. Severity WARNING FABS-1006 Message , [FABS-1006], ,, WARNING, , : object unit Probable Cause Indicates that there is no device in the slot with the specified object type ID in the system module record. This could indicate a serious Fabric OS data problem on the switch. The possible values for function name and description of problem are: • setSoftState: bad object • setSoftState: invalid type or unit • media_sync: Media oid mapping failed • fabsys_media_i2c_op: Media oid mapping failed • fabsys_media_i2c_op: obj is not media type • media_class_hndlr: failed sending media state to blade driver Recommended Action If the message is isolated, monitor the error messages on the switch. If the error is repetitive or if the fabric failed, fail over or reboot the switch. If the message persists, run the firmwareDownload command to update the firmware. Severity WARNING FABS-1007 Message , [FABS-1007], ,, WARNING, , : Media state is invalid - status= Probable Cause Indicates that the Fabric OS has detected an invalid value in an object's status field. This is usually an internal Fabric OS problem or file corruption. Recommended Action Reboot or power cycle the switch. If the message persists, run the firmwareDownload command to update the firmware. 184 Fabric OS Message Reference 53-1001338-01