HP StorageWorks 8/40 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 591
SEC-1101, Probable Cause, Recommended, Action, secFabricShow, Severity, Message, configDownload
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 591 highlights
90 SEC-1101 Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1101 Message , [SEC-1101], ,, ERROR, , Failed to enable security on all switches. Please retry later. Probable Cause Indicates the security enable failed on the fabric because one or more switches in the fabric are busy. Recommended Action Verify that the security event was planned. If the security event was planned, run the secFabricShow command to verify that all switches in the fabric are in the ready state. When all switches are in the ready state, retry the operation. Severity ERROR SEC-1102 Message , [SEC-1102], ,, ERROR, , Fail to download . Probable Cause Indicates the switch failed to download a certificate, security database, or policies. This can happen when the switch does not have enough resources to complete the operation, the fabric has not stabilized, or the policy database is an invalid format. Recommended Wait for fabric to become stable and then retry the operation. If the policy database is in an illegal Action format (with configDownload), correct the format and retry the operation. Severity ERROR SEC-1104 Message , [SEC-1104], ,, ERROR, , Fail to get primary . Probable Cause Indicates the switch failed to get either the primary certificate or a primary public key. Recommended Action Verify the primary switch has a valid certificate installed and retry the operation. If a valid certificate is not installed, install a certificate by following the procedure specified in the Secure Fabric OS Administrator's Guide. Fabric OS Message Reference 521 53-1001338-01