HP StorageWorks 8/40 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 327
FICU-1007, Recommended, Action, Severity, Message, Probable Cause, memShow, supportFtp, supportSave
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 327 highlights
36 FICU-1007 Recommended Check if the FICON channel corresponding to the PID in the message is functioning correctly. Action Severity WARNING FICU-1007 Message , [FICU-1007], ,, WARNING, , : Failed to allocate memory while performing . Probable Cause Indicates that memory resources are low. This might be a transient problem. Recommended Action If the message persists, check the memory usage on the switch, using the memShow command. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING FICU-1008 Message , [FICU-1008], ,, WARNING, , FMS mode has been enabled. Ports: have been disabled due to port address conflict. Probable Cause Indicates that the specified ports were disabled when Fibre Connectivity (FICON) Management Server mode (fmsMode) was enabled. This is due to a port address conflict or the port address being reserved for the CUP management port. Recommended No action is required. Action Severity WARNING FICU-1009 Message , [FICU-1009], ,, WARNING, , FMS Mode enable failed due to insufficient frame filtering resources on some ports. Probable Cause Indicates that the frame filtering resources required to enable Fibre Connectivity (FICON) Management Server mode (fmsMode) were not available on some of the ports. Recommended Use the perfDelFilterMonitor command to delete the filter-based performance monitors used on all Action ports to free up the resources. Severity WARNING Fabric OS Message Reference 257 53-1001338-01