HP Workstation i2000 hp workstation i2000 processor installation (a6037-90060) - Page 13

Power Supply Door in Opened Position

Get HP Workstation i2000 PDF manuals and user guides View all HP Workstation i2000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

hp workstation i2000 Peripheral Power Harness Baseboard E-PAC Baseboard Power Harness Processor E-PAC Figure 4. Power Supply Door in Opened Position 7. Open the power supply door (as shown in Figure 4) by pulling upwards and allowing the door to swing outwards until the metal clip (near the top of the system) is engaged with a "click". The power supply door is now locked into an open position for system access. 8. Remove the baseboard E-PAC (black Styrofoam protective material as shown in Figure 4).  NOTE This E-PAC material is required for proper operation of the system and must be replaced in the same position before closing the system after servicing. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
hp workstation i2000
13
Figure 4. Power Supply Door in Opened Position
7.
Open the power supply door (as shown in Figure 4) by pulling upwards and
allowing the door to swing outwards until the metal clip (near the top of the
system) is engaged with a "click".
The power supply door is now locked into an
open position for system access.
8.
Remove the baseboard E-PAC (black Styrofoam protective material as shown in
Figure 4).
NOTE
This E-PAC material is required for proper operation of the
system and must be replaced in the same position before
closing the system after servicing.
Baseboard
Power Harness
Processor
E-PAC
Peripheral
Power
Harness
Baseboard
E-PAC