HP XP20000/XP24000 HP StorageWorks XP24000/XP20000 Disk Array Site Preparation - Page 66

Moving racks, Removing packing materials for the XP20000, Removing packing materials

Page 66 highlights

10. Visually check the unit for any damage. If any damage is visible, report it immediately to HP and the shipping carrier. Moving racks Use care when moving racks with casters. • Sudden stops, excessive force, and uneven surfaces may cause the product to overturn. • The XP rack has casters which are fixed in the front and swivel in the rear for stability and safety. Therefore, for maneuverability (when moving the rack into a tight spot) it is easier to move the rack with the back as the leading edge (lead with the rear, swiveling casters). For long, straight runs, where maneuverability is not much of a concern, roll the rack with the front, fixed casters leading. • When rolling the rack, make sure to push firmly on the front door frame and not the door mesh. Removing packing materials for the XP20000 Figure 20 Removing packing materials . Figure 21 Installing the ramp and de-staging the disk array . 66 Delivery and unpacking

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78

10.
Visually check the unit for any damage. If any damage is visible, report it immediately to HP and
the shipping carrier.
Moving racks
Use care when moving racks with casters.
Sudden stops, excessive force, and uneven surfaces may cause the product to overturn.
The XP rack has casters which are fixed in the front and swivel in the rear for stability and safety.
Therefore, for maneuverability (when moving the rack into a tight spot) it is easier to move the
rack with the back as the leading edge (lead with the rear, swiveling casters). For long, straight
runs, where maneuverability is not much of a concern, roll the rack with the front, fixed casters
leading.
When rolling the rack, make sure to push firmly on the front door frame and not the door mesh.
Removing packing materials for the XP20000
Figure 20 Removing packing materials
.
Figure 21 Installing the ramp and de-staging the disk array
.
Delivery and unpacking
66