HP Xw460c HP BladeSystem Onboard Administrator Command Line Interface User Gui - Page 64
Set Oa Uid, Set Ipconfig, Set Ntp Poll
![]() |
View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
SET OA UID • Command: SET OA UID [] {ON | OFF} • Description: Sets the Onboard Administrator UID on or off. If you do not specify a bay number, the command defaults to the active Onboard Administrator. • Access level/Bay level: All • Restrictions: None SET IPCONFIG • Command: SET IPCONFIG {DHCP | STATIC} [] [DYNAMICDNS] [ [ []]] • Description: o Configures IP settings for the Onboard Administrator to DHCP mode or static mode. o In STATIC mode, the IP address and Netmask are set to and respectively. These settings take affect immediately. If the Gateway address and/or DNS addresses are cleared, they are omitted. The Gateway and DNS address can also be set by using the SET OA GATEWAY and ADD OA DNS commands. o SET IPCONFIG STATIC [] [ [ []]] o In DHCP mode, the IP address, Netmask, Gateway address, and DNS addresses are obtained from the DHCP. This setting immediately takes affect. If DYNAMICDNS is specified, then the DNS server is notified of the new IP address of the system when it is received from the DHCP server. o SET IPCONFIG DHCP [] [DYNAMICDNS] • Access level/Bay level: OA administrator, OA operator • Restrictions: None SET NTP POLL • Command: SET NTP POLL • Description: Sets the polling interval of the NTP servers Enclosure network configuration commands 64
![](/manual_guide/products/hewlettpackard-xw460c-hp-bladesystem-onboard-administrator-command-line-interface-user-guide-version-260-be1f331/64.png)