HP Xw460c HP BladeSystem Onboard Administrator Command Line Interface User Gui - Page 66
Set Snmp Community, Set Snmp Location, Show Network
View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
SET SNMP COMMUNITY • Command: SET SNMP COMMUNITY {READ | WRITE} "" • Description: Sets the community name for the read or write SNMP community. If a blank write community name is given, then SNMP set commands are disabled until a non-empty community name is given. • Access level/Bay level: OA administrator, OA operator • Restrictions: o The write must be no more than 20 characters long, and the read must be 1 to 20 characters long. o All printable characters are valid. o The default read community name is public. o The default write community name is public. SET SNMP LOCATION • Command: SET SNMP LOCATION "" • Description: Configures the SNMP location of the enclosure. The default location is blank. • Access level/Bay level: OA administrator, OA operator • Restrictions: The must be no more than 20 characters long. Valid characters are all alphanumeric, the underscore (_), the dash (-), and spaces. SHOW NETWORK • Command: SHOW NETWORK • Description: Displays: o Enclosure o DHCP state o Dynamic DNS state o IP address subnet mask o Gateway address o Primary and secondary DNS addresses Enclosure network configuration commands 66