HP Xw8200 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 171

container Commands container unmirror To unmirror a mirror set, resulting in a single-partition volume set and freespace, use the container unmirror command. Note that there is no equivalent command for a multilevel array of mirror sets. To unmirror a multilevel array of mirror sets, use this command for each underlying mirror set. Syntax container unmirror {container} Parameters {container} Specifies the ID number (0 to 63) of the mirror set to unmirror. You previously created the mirror set by using the container create mirror or container create mmirror command. Examples Before unmirroring a mirror set, use the container list command to obtain information about any existing arrays. As the following example shows, there is one existing array (array 0, a mirror set) on this controller at the time the mirror set is unmirrored: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Dr Label Type Size Ctr Size Usage C:ID:L 0 Mirror 10.0MB NTFS 0:02:0 0:03:0 State ----Normal Note that the example eliminates some items in the container list display so that you can see an example of the State column. 5-123