HP Xw8200 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 262

Adaptec SCSI RAID Software Reference Guide task suspend To suspend one or all tasks running on the currently opened controller, use the task suspend command. Syntax task suspend [/all{=boolean}] Parameters {integer} Specifies the task ID for the task to suspend. Perform a task list /all to display the task IDs for all tasks currently running on the open controller before suspending a specific task or all tasks. Switches /all{=boolean} Specifies whether to suspend all running tasks. If you set this switch to TRUE, the command suspends all tasks that were running on the currently opened controller. If you do not specify this switch or a valid task ID, the command displays an appropriate error message. Examples Before suspending a running task, use the task list command to identify any currently running tasks, as in the following example: AAC0>task list Executing: task list TaskId Function Done% Array 101 Scrub 24.6% 0 State ----RUN Specific1 --------00000000 Specific2 --------00000000 The following example shows the use of the task suspend command to suspend task 101: AAC0> task suspend 101 Executing: task suspend 101 10-12