HP Xw8200 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 76

Adaptec SCSI RAID Software Reference Guide AAC0>container create raid5 /stripe_size=64K /scrub ((0,02,0),10M) (0,03,0) (0,04,0) (0,05,0) Executing: container create raid5 /stripe_size=65,536 / scrub=TRUE ((CHANNEL=0,ID=2,LUN=0),10,485,760 ) (CHANNEL=0,ID=3,LUN=0) (CHANNEL=0,ID=4,LUN=0) (CHANNEL=0,ID=5,LUN=0) container 0 created As the command executes, note that the title bar of the MS-DOS window displays the status of the command. For example: Stat:OK!Task:101,Func:R5S Ctr:0,State:RUN 84.6% See page 3-10 for detailed information on the status information that the command displays in the title bar as it executes the task. On UNIX systems, the message displayed after you execute the container create raid5 command includes the root special file associated with the newly created RAID-5 set. Use the container list command after using the container create raid5 command to display information about the RAID-5 set. AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 RAID-5 30.0MB 64KB None 0:02:0 64.0KB: 10.0MB 0:03:0 64.0KB: 10.0MB 0:04:0 64.0KB: 10.0MB 0:04:0 64.0KB: 10.0MB The following list describes the columns that contain information as a result of creating a RAID-5 set with the container create raid5 command: ■ The Num Label column displays the ID number of the newly created RAID-5 set, which in the example is 0. If you specify a label when creating the RAID-5 set, it appears in this column. Because no label was specified when the RAID5 set was created, no label appears in the column. On UNIX systems, the root special file associated with the RAID-5 set also appears in this column. 5-28