HP Xw8200 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 269
enclosure identify slot, the command stops
UPC - 882780210455
View all HP Xw8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 269 highlights
enclosure Commands enclosure identify slot To identify a slot on a specified SAF-TE enclosure management device, use the enclosure identify slot command. Typically, an enclosure management device indicates to the operator which slot is currently being identified by flashing an adjacent light. Syntax enclosure identify slot {enclosure} {slot} Parameters {enclosure} Specifies the ID associated with the enclosure management device on which you want to identify a slot. For this version, the controller supports a maximum of eight enclosure management devices on each bus. {slot} Specifies the unit number associated with the slot. This is the slot that you want the enclosure management device to identify. This unit number can range from 0 to 15 inclusive. Typically, the slot unit number is limited by the physical number of device slots in the enclosure management device. Switches /stop{=boolean} Specifies whether to stop the identification of the specified slot. If you set this switch to TRUE, the command stops identification of the specified slot. Typically, you use this switch to stop the identification of a slot that you previously identified with the enclosure identify slot command. This switch defaults to FALSE. Examples The following example shows how to identify slot 1 in enclosure management device 0 using the enclosure identify slot command: AAC0>enclosure identify slot 0 1 Executing: enclosure identify slot 0 1 11-5