HP Xw8200 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 287
device_id}, enclosure show slot, controller, pause_io, to SCSI device ID
UPC - 882780210455
View all HP Xw8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 287 highlights
enclosure Commands {device_id} Specifies the ID (0 through 15 inclusive) of the SCSI device you want to assign to the specified device slot. Examples Before setting a device slot to a specific SCSI ID, you might want to use the enclosure show slot command to determine the current SCIS ID setting for the device slots, as in the following example: AAC0>enclosure show slot Executing: enclosure show slot Enclosure Slot scsiId Insert Status 0 0 0:00:0 4 OK NOTACTIVATE 0 1 0:01:0 0 OK UNCONFIG ACTIVATE 0 2 0:10:0 0 OK UNCONFIG ACTIVATE 0 3 0:03:0 0 OK UNCONFIG ACTIVATE 0 4 0:04:0 0 OK UNCONFIG ACTIVATE 1 0 1:00:0 0 OK CONFIG ACTIVATE 1 1 1:01:0 0 OK UNCONFIG ACTIVATE 1 2 1:10:0 0 OK UNCONFIG ACTIVATE 1 3 1:03:0 0 OK UNCONFIG ACTIVATE 1 4 1:04:0 0 OK UNCONFIG ACTIVATE The following example sets device slot 2 on enclosure management device 0 to SCSI device ID 05. The example also shows how to pause all I/O activity on the controller by using the controller pause_io command: AAC0>controller pause_io 30 Executing: controller pause_io 30 AAC0>enclosure set scsiid 0 2 5 Executing: enclosure set scsiid 0 2 5 You may want to use the enclosure show slot command again to see the change in the SCSI ID setting, as in the following example: AAC0>enclosure show slot Executing: enclosure show slot Enclosure Slot scsiId Insert Status 0 0 0:00:0 4 OK NOTACTIVATE 0 1 0:01:0 0 OK UNCONFIG ACTIVATE 0 2 0:05:0 0 OK UNCONFIG ACTIVATE 0 3 0:03:0 0 OK UNCONFIG ACTIVATE 0 4 0:04:0 0 OK UNCONFIG ACTIVATE 1 0 1:00:0 0 OK CONFIG ACTIVATE 1 1 1:01:0 0 OK UNCONFIG ACTIVATE 1 2 1:10:0 0 OK UNCONFIG ACTIVATE 11-23