HP Xw9300 NVIDIA: RAID Users Guide - Page 35
Installing the RAID Drivers, - scsi setup
View all HP Xw9300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
CHAPTER 2 Setting Up Your RAID Configuration Installing the RAID Drivers 1 After you complete the RAID BIOS setup, boot from the Windows CD. The Windows Setup program starts. 2 Press F6 and wait a few moments for the Windows Setup screen to appear. Windows Setup Setup could not determine the type of one or more mass storage devices installed in your system, or you have chosen to manually specify an adapter. Currently, Setup will load support for the following mass storage device(s): * To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for use with Windows, including those for which you have a device support disk from a mass storage device manufacturer, press S. * If you do not have any device support disks from a mass storage device manufaturer, or do not want to specify additional mass storage devices for use with Windows, press ENTER. S=Specify Additional Devices ENTER=Continue Figure 2.20 Windows Setup-Specify Devices F3=Exit 3 Specify the NVIDIA drivers. a Insert the floppy that has the RAID driver, press S, then press Enter. The following Windows Setup screen appears:: Windows Setup You have chosen to configure a SCSI Adapter for use with Windows, using a device support disk provided by an adapter manufacturer. Select the SCSI Adapter you want from the following list, or press ESC to resutrn to the previous screen. NVIDIA RAID CLASS DRIVER (required) NVIDIA NForce Storage Controller (required) Enter=Select F3=Exit Figure 2.21 Windows Setup-Select SCSI Adapter NVIDIA Corporation 31