HP Z6100 HP Designjet Z6100 Printer Series - Setup Poster (42 inch) - Page 4

15 Use two screws on the outside of the right leg to attach the right leg to the cross-brace. x2 16 Use four screws to attach the cross-bar to the legs. x4 17 Notice that there is anti-slip material around two of the wheels on the feet. DO NOT REMOVE this material yet. 18 Place a foot on the left leg. There are pins to help you correctly position the foot. Do not remove the anti-slip material from the wheel. 19 Use four screws to attach the foot to the left leg. Tighten each screw half-way, and then gradually tighten each screw completely. x4 20 Position the other foot on the right leg. There are pins to help you correctly position the foot. Do not remove the anti-slip material from the wheel. 21 Use four screws to attach the foot to the right leg. Tighten each screw half-way, and then gradually tighten each screw completely. x4 Page 4 22 Roll the stand assembly into its upright position. x2