HP mp3135w HP mp3130 digital projector - (English) User Guide - Page 62
Adjust picture > Aspect
View all HP mp3135w manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Fixing Problems If the image is out of focus: ❏ Be sure the lens cap is removed. ❏ While displaying the on-screen menu, adjust the focus ring. (The image size should not change; if it does, you are adjusting the zoom not the focus.) ❏ Ensure the projection screen is 1.2 to 12 m (4 to 40 ft) from the projector. ❏ For a computer connection, set the display resolution on the computer to 1024 x 768 pixels. ❏ Check the projection lens to see if it needs cleaning. If an upside-down or reversed image is displayed: ❏ The projector has been set to the wrong position setting. Open the on-screen menu, select Setup > Projector position, and select the correct setting. If the image is too small or too large: ❏ Adjust the zoom ring on top of the projector. ❏ Be sure the projector is 1.2 to 12 m (4 to 40 ft) from the projection screen. ❏ Open the on-screen menu and select Adjust picture > Aspect ratio. Set to Best Fit or Fill. For a wide-screen picture, try setting the aspect ratio to 16:9. If the image has slanted edges: ❏ As much as possible, reposition the projector so that it is centered on the screen and below the bottom or above the top of the screen. ❏ The projector can automatically correct slanted sides of the picture when the projector is tilted up or down. However, additional corrections might be required in certain situations. Open the on-screen menu and select Adjust picture > Keystone correction. Adjust the horizontal and vertical settings as needed or enable or disable the auto keystone correction. 62 User's Guide