HP rp7420 Installation Guide, Fifth Edition - HP 9000 rp7420 Server - Page 36
Unpacking a Non-Racked Server, Unloading with a Lifter - weight
View all HP rp7420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Unpacking the Server Unpacking a Non-Racked Server Unpacking a Non-Racked Server NOTE If this server was delivered with a wheel kit, proceed to the chapter titled "Installing Additional Components". NOTE HP recommends the use of a lifter, such as a RONI Company model 17000 SP 400 lifting device, when moving a non-racked system, shown in Figure 2-5. If no lifter is available, install the lift handle panels provided with the system. Unloading with a Lifter Use the following procedure to unload the server from the pallet using a lifter. WARNING Use caution when using a lifter. Because of the weight of the server, it must be centered on the lifter forks before raising it off the pallet to avoid injury. Never extend more than one server from the same cabinet while installing or servicing another server product. Failure to follow these instructions could result in the cabinet tipping over. 36 Chapter 2